CORE AREAS
- Fixed Platforms – Topsides, Jackets, MOPU, CPP
- Floating Platforms – FPSO, FSRU, FPU, FSO, FLNG
- Brownfield Modifications.
MAJOR ENGINEERING ACTIVITIES
- Bid Support, Pre-FEED, FEED, Detailed Engineering, As Built.
ENGINEERING
The following disciplines to carry out the detailed engineering and prepare engineering deliverables for the project and to get the final design approved.
- Process
- Piping
- Topside Structural
- Mechanical
- Electrical
- Instrumentation control & Telecommunication
- Projects and Planning
PROCESS
- Process Simulation & Process Optimization.
- Design Basis / Philosophies.
- Flow Sheet development with Heat and Material balances
- Preparation of PFD and P&ID
- Specifications for Process Equipment and Instruments
- Basic Engineering Package for Process Units, Utilities
- Process Control Philosophy
- Process Shutdown Philosophy (Normal & Emergency)
- Cause and Effect Diagram
- Assistance for HAZOP Studies
PIPING
- Detail Layout for Overall Topside
- Design Basis
- Equipment Layout Drawings
- Piping & Valve Materials Specifications
- Specifications for Specialty Items
- Piping General Arrangement (GA)
- Piping Isometrics
- Pipe Stress Analysis.
- Pipe Support Design
- Material Take Off (MTO)
- 3D Modelling.
MECHANICAL
- Preparation of Data Sheets and Purchase Specifications
- Requisitioning and Review of Vendor Drawings/Specifications.
- Vibration Analysis
STRUCTURAL
- Design, modelling and analysis- offshore structures.
- Design Basis
- Structural Analysis - In-place- In-service- Transportation-Heavy lift
- On Bottom Stability Analysis
- Boat Impact Analysis
- Fatigue Analysis
- Pushover Analysis.
- Seismic Analysis
- Pile Driveability Analysis
- Conductor Driveability Analysis
- Reports
- Design of modular structures, integrated units, multilevel units
- Structural Drafting, 3D Modelling.
- Bill of Quantities and material specifications
- Local and Global strength analysis, hydrodynamic - model analysis
- Load outs, float off, and float over analysis.
INSTRUMENT CONTROL & TELECOMMUNICATION
- Control Philosophy and Specifications
- Detailed Engineering and Specifications for: Distributed Control Systems, Programmable Logic Controllers, Emergency Shut Down Systems
- Fire and Gas Detection System Philosophy and Specification
- Sizing of Control Valves, Flow Elements, Safety Valves, etc.
- Integrated control and safety system functional specification
- Data Sheets/Specifications for Instruments, Control Valves, Safety Relief Valves etc.
- Instrument Bulk Material Take-off
- Cable Selection and Scheduling
- Control Room Design including Panel, Console Layouts
- Cable Tray Layout and Conduit Routing
- Instrument Installation Hook-ups
- Instrument Loop Diagrams
- Instrument Indexing
- Review of Vendor Drawings and Documents
ELECTRICAL
- Power System Studies: Load Flow, Short Circuit, Motor Starting etc
- Power Generation and System Design
- Single Line Diagrams (SLDs)
- Protection Relay Coordination Diagram
- Cable System Design, Scheduling and Take - off
- Lighting System Design
- Uninterrupted Power Supplies (UPS) - Design and- Specification
- Cable & Equipment layout
- Electrical Terminal Connection Diagram
- Requisitioning and Review of Vendor Drawings/Specifications
PROJECT MANAGEMENT CONTROL & PLANNING
- All Engineers with exposure to Project Management and Planning Skills.
- Site Execution experience on Multi discipline projects (Within Time, Budget & Resource).
- Contract negation skills & Experienced in Project Planning.
- Project Managers are safety Conscious.
- Preparing Project Execution & Cost Estimation Plan for the Projects.
- Engineering Design Internal Quality Audits.
- Engineering Coordination with Package Vendors.
- Experience in project close out and handing over.
